Panasonic PV-500, User Manual

Page: 364 / 494

362
O
pe
ra
tio
n a
n
d D
a
ta
O
ut
put
t
hr
ou
gh I
/O
T
e
rm
ina
ls
C
h
ap
te
r 8
Output
No. Signal No. Signal
1 COMMON FLASH 0 designated common 2 FLASH 0 Flash signal for Camera 0
3 COMMON FLASH 1 designated common 4 FLASH 1 Flash signal for Camera 1
5 COMMON FLASH 2 designated common 6 FLASH 2 Flash signal for Camera 2
7 COMMON FLASH 3 designated common 8 FLASH 3 Flash signal for Camera 3
9 READ END 0 Image capture with Camera 0
complete 10 READ END 1 Image capture with
Camera 1 complete
11 READ END 2 Image capture with Camera 2
complete 12 READ END 3 Image capture with
Camera 3 complete
13 READY Ready completion signal 14 ERROR 0 Error signal 0
15 ACCEPT Signal of acceptance the next
signal
• TYPE
• DISPLAY
• REENTRY*1
• ASSIGN*2
16 ERROR 1 Error signal 1
17 RESULT Total Judgement 18 TACT Inspection data read timing
19 STROB Data output complete 20 RUN Running status (On when
running)
21 OUT 0 Output data 0-15 22 OUT 1 Output data 0-15
23 OUT 2 24 OUT 3
25 OUT 4 26 OUT 5
27 OUT 6 28 OUT 7
29 OUT 8 30 OUT 9
31 OUT 10 32 OUT 11
33 OUT 12 34 OUT 13
35 OUT 14 36 OUT 15
37 COMMON Common for output 38 COMMON Common for output
39 NC* Unconnected 40 NC* Unconnected
*NC = No connection
The output commons (No.37, 38) are for No.9 to 36. When you use Flash signals (Flash 0-3), connect with
respective designated commons (Pin No.1, 3, 5, 7).
*1: It cannot be accepted when ReadEnd signal is Off.
*2: Excepting when assigning function of “Abort Inspection/Process”.