Panasonic PV-500, User Manual

Page: 413 / 494

411
C
o
nt
rol
w
it
h C
om
m
uni
c
a
tion P
or
t
C
h
ap
te
r 9
INDE
X
Write Command
This is a command that changes the setting value of PV500. Writing is available only when being in RUN mode
and displaying RUN menu. For the information of writable data, refer to the next page.
When writing one of data (such as System Register, maximum
value, or minimum value)
Send % P W Parameter = Data BCC CR
Receive % P W $ Parameter BCC CR
Error (ERROR 1 signal = ON)
% P W ! Error code (3-digit) BCC CR
Example: Writes the value “3.14” in System Register 0.
Send
% P W S Y S : R E G 0 = 3 . 1 4 BCC CR
Receive
% P W $ S Y S : R E G 0 BCC CR
When writing two of data (such as maximum value and
minimum value)
Send % P W P Parameter = Data 1 , Data 2 BCC CR
Receive
% P W P $ Parameter BCC CR
Error (ERROR 1 signal = ON)
% P W P ! Error code (3-digit) BCC CR
Example: Writes a maximum value of “100” and a minimum value of “50” in Numerical Calculation
No.10. CACnnn:LPAIR
Parameter for changing the maximum and minimum values in Numerical Calculation
"CACnnn:LPAIR"
Send
% P W P C A C 0 1 0 : L P A I R
= 5 0 , 1 0 0 BCC CR
Minimum Maximum
Receive
% P W P $ C A C 0 1 0 : L P A I R BCC CR
Error codes for Write command
200 Operation is stopped.
251 Although PV500 is operating (RUN), displaying SETUP menu cannot write.
251
Specification of the parameter is wrong. (Undefined parameter is specified.)
252
• The specified parameter does not exist. (e.g. The number of uncreated checker is specified as a
parameter.)
• The specified parameter value is out of the settable range. (e.g. Maximum value of slice level is
being set to over 256.)
• The specified values led to the status of “Maximum value < Minimum value” when entering them.
• (When specifying the moving distance of marker)
A part of the circumscribing rectangle of the marker (the intersection point when Shape is
Cross line) after move was out of the nine screens where checker area is settable.
254 The number of write commands received by PV500 exceeds the receivable number when executing
one inspection.