Panasonic PanaVoice Courier, Installation Manual

Page: 26 / 141

PanaVoice Courier Installation Manual 25
COURIER PROGRAMMING
B
O O T I N G T H E
A
P P L I C A T I O N
Once the Courier & DBS physical hardware has been established, it is time to turn on the
PC, and boot the application.
You will notice during this boot procedure, several programs that are launching. Most of
these programs will remain minimized at the bottom of the screen (to the right of the
“Start” icon). Some will launch quickly, and not be minimized. The following programs
will launch during the boot procedure:
•
Windows
•
PC Anywhere
•
Voice Card Drivers
•
Choose API Integrated or In-Band
•
Service Overlord
•
Winsock Overlord Broadcast
•
Serial Overlord
•
Courier Engine
Note: During the boot procedure, do not attempt to minimize, close, expand, etc. any program
that is launching. The boot procedure will be completed when the final program (Courier Engine
Ver. xxx) appears in lower task bar at the far right.
The following boot sequence will load when the system is powered on:
Note: Only Sequence 1 and 2 are different on the Courier UMS. The remaining Sequence steps
are the same for all units.
1. Basic hard drive initialization
Courier and Courier Plus
Hard drive initialization will take approximately 20 seconds. Here you will recognize
basic text over a black background.
Courier UMS
Courier NT start up screen will appear prompting the user to select either NT 4.0 or
NT 4.0 VGA. There is no need to make an entry. NT 4.0 will automatically load after
4 seconds.
2. OPERATING SYSTEM LOADS
Courier and Courier Plus
The next program to boot is the Windows O/S. During this procedure, the Windows
98 banner will appear, and last for approximately 15 seconds.
Courier UMS
OS Loader text flashes very quickly and then NT 4.0 loads for 20 seconds. During
this time you will see the operating system version and service version