Panasonic LP-RH Series, Setup And Maintenance Manual

Page: 229 / 240

229
ERROR
CODE
Description Measures *1
E640 *3
E641 *3
Lasing operation/shutter open operation was
cancelled due to a timeout after the laser start-
up check.
Try again.
(Details: For the first operation of opening shutter
or lasing after the laser pumping on, warning
E640/E641 may occur and the requested
operation is canceled in case the laser pumping
has been off for more than several days and time
for laser start-up check (maximum 30 seconds)
is needed.)
• When operating with Laser Marker NAVI smart,
retry to start test marking/laser radiation for
measurement/run mode operation.
• When operating in remote mode, close the shutter
or input the alarm reset to recover from the
warning status, and then retry opening the shutter
or laser radiation for measurement.
E652
Font file data are incorrect. Unable to read the
font file.
• Re-register font data on the data management
screen.
• Check the font data file format.
E653
Graphic file data are incorrect. Unable to read
the graphic file.
• Re-register graphic data on the data management
screen.
• Check the graphic data file format.
E654
Font file is not registered to the font No.
specified.
• Register the font file on the data management
screen.
• Using the character conditions, specify the font
No. in which the font file is registered.
E655
Insufficient font memory. Font file data capacity
is too large.
• Reduce the number of characters registered in the
font file.
• Delete unnecessary font files.
E656 The specified graphic file was not registered.
Register the graphic file in the data management
screen.
E657
No font corresponding to set characters were
found.
• Change characters, or add the font data in use.
• To use Japanese or Simplified Chinese
characters, set “East Asian characters” in file
settings.
E658 Too large number of characters.
• Decrease the number of characters.
• Set the characters by separating them into several
objects.
E659 Existed invalid character for bolding with setting.
• Original4 font cannot be displayed in bold. Select
another font.
• Use Font Maker software provided to create the
proper pattern font.
E660
Bold characters cannot be created due to the
combination of set bold line width, character
height, and character width.
• Set the bold line width to half or less of the
character height or the character width, whichever
is smaller.
• When marking the bold character, set the
comparison ratio between character height and
width at 1/10 to 10.
ME-LPRH-SM-3