Panasonic LP-RH Series, Setup And Maintenance Manual

Page: 123 / 240

123
4-6-5 On-the-fly marking: Single trigger
ON (Open)
OFF (Close)
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
T3
T2 T2
T4
T5 T5
T4
T3
T1
SHUTTER OPEN OUT
(No.39)
READY OUT (Y5)
TRIGGER IN (X5)
PROCESSING OUT (Y10)
LASING OUT (No.40)
PROCESSING END OUT
(Y11)
Item Time Remarks
T1 ― Time for marking data creation. It varies depending on the quantity of the setting data.
T2 2ms or more Keep the ON status for 2ms or more.
T3 ― Time from when TRIGGER IN (X5) is turned on till when the workpiece comes to the
preset marking position.
T4 2 to 510ms This is the output to notify that the marking trigger processing completed normally. This is
One-shot output. Set the output time on System settings screen. There is a small margin of
error for the setting value.
T5 ― Time for marking data creation.
When the next marking data is not ready during the marking operation, this is the rest time
for data creation.
When the next marking data is ready during the marking operation, this takes less than
1ms.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• If the counter is reset during on-the-fly marking operation, READY OUT (Y5) turns off momentary and there is a case
that the next marking could not be executed due to Warning E751.
ME-LPRH-SM-3