Panasonic LP-RH Series, Setup And Maintenance Manual

Page: 127 / 240

127
4-6-9 Target detection input
TRIGGER IN (X5)
PROCESSING OUT (Y10)
TARGET DETECTION IN (X7)
PROCESSING END OUT (Y11)
PROCESSING FAIL OUT (Y12)
CHECK OK OUT (No.34)
CHECK NG OUT (No.35)
WARNING OUT (Y14)
LASING OUT (No.40)
READY OUT (Y5)
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON (Normal)
OFF (Error)
T2
T1
T2
T3
T2
T4 T4 T4
T5 T5
T5
T1
T6
T3
Item Time Remarks
T1 2ms or more Keep the ON status for 2ms or more.
T2 0 to 9999 ms When the trigger delay time is set in the selected file, trigger processing (lasing) operation
starts after the delay time.
T3 1 ms or more When TARGET DETECTION IN (X7) turns ON for more than 1ms while LASING OUT
(No.40) is ON, it is judged as success of the target detection.
T4 2 to 510 ms This is the output to notify that the marking trigger processing completed normally. Even
when the workpiece could not be detected, PROCESSING END OUT (Y11) turns on unless
the trigger processing operation is interrupted. This is One-shot output. Set the output time
on System settings screen. There is a small margin of error for the setting value.
T5 2 to 510 ms According to the ON/OFF state of TARGET DETECTION IN (X7), CHECK OK OUT (No.34)
or CHECK NG OUT (No.35) turns on for one-shot time after the trigger processing (lasing)
operation. The one-shot output time is set on the system settings screen. There is a small
margin of error for the setting value.
• When TARGET DETECTION IN (X7) turns ON for more than 1ms during lasing
operation: CHECK OK OUT (No.34) turns ON.
• When TARGET DETECTION IN (X7) did not turn ON during lasing operation: CHECK
NG OUT (No.35) turns ON.
T6 Approx. 3 sec. When TARGET DETECTION IN (X7) did not turn ON during lasing operation, the warning
E752 is output for 3 seconds.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• Before using TARGET DETECTION IN (X7), set X7: TARGET DETECTION IN to “Enabled” at the system settings of
Laser Marker NAVI smart.
ME-LPRH-SM-3