Panasonic LP-RH Series, Setup And Maintenance Manual

Page: 40 / 240

40
6. Ports for industrial network: EtherNet/IP or PROFINET *1
The ports for the optional network unit (EtherNet/IP unit or PROFINET unit).
Communication port (2-port switch) to control the laser marker by the industrial network with the control device such
as a PLC.
Connect a LAN cable.
For details, refer to “EtherNet/IP Communication Guide” or “PROFINET Communication Guide”.
If you do not install the network unit, there is no port here.
7. I/O terminal block: TERMINAL
The terminal block to connect I/O signals used for the external control of the laser marker.
Connect the attached terminal block.
Refer to “4-2 Signals and Details of I/O Terminal Block” (P.92) for details.
8. USB port A (2 port): USB *2
The commercially available USB flash drive or USB mouse can be connected when the optional expansion board in
installed to the controller.
The USB flash drive is used to register and save the marking data when the touch panel console or monitor is
connected to the laser marker and used.
If you use a commercially available monitor when operating the laser marker, the USB mouse can be connected to
this terminal.
The USB port is also installed to the front of the controller.
ワㄐㄕㄊ㄄ㄆ
• Do not connect any device other than a USB flash drive or USB mouse to the USB port.
• USB flash drive with security function cannot be used. The supported format for USB flash drive are FAT32 or
exFAT.
• USB hubs cannot be used.
9. VGA connector: VGA *2
The connector to connect the commercially available monitor when operating the laser marker.
The monitor and mouse are available when the optional expansion board is connected to the controller. Refer to “2-6-
6 Connection of Monitor and Mouse” (P.66).
10. LAN port for extensions: INFO LAN *2
Not used in this product. Do not connect anything.
11. Displacement sensor connector: D-SENSOR *2
Not used in this product. Do not connect anything.
12. I/O connector: I/O CONNECTOR
The connector to connect I/O signals used for the external control of the laser marker.
For details, refer to “4-3 Signals and Details of I/O Connector” (P.101).
13. AC power supply terminal: AC INPUT
Terminal for connecting AC power supply.
Power voltage: 90V to 132V or 180V to 264V AC (inc/-10% voltage fluctuations), 50/60Hz (Frequency switches
automatically.)
Use the specified optional cable or a cable with the enough rating capacity to fulfil the power voltage specification of
this product, which is compliant with the regulations and standards in the country or region where it is used.
For the optional cables, refer to “1-4-3 Cables” (P.32).
ワㄐㄕㄊ㄄ㄆ
• Be sure to connect the ground pin of the AC power cable to earth permanently. Refer to “2-6-2 Power connection
and earth (Grounding)” (P.60).
ME-LPRH-SM-3