Panasonic LP-RH Series, Setup And Maintenance Manual

Page: 126 / 240

126
4-6-8 On-the-fly marking: 2 sensors input
When trigger mode is set to Single trigger
TRIGGER IN (X5)
PROCESSING OUT (Y10)
ENCODER A IN (X13)
ENCODER B IN (X14)
SHUTTER OPEN OUT (No.39)
LASING OUT (No.40)
READY OUT (Y5)
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
T2
T1 T6
T3
T5 T5 T5
T4 T4
Speed A
Speed A
Speed B
Speed B *2 Undefined *1
Applied line speed
Speed C
Speed C
*1 : If TRIGGER IN (X5) is turned ON without proper detection of the line speed, warning E607 occurs.
*2 : When ENCODER B IN (X14) is input during the trigger processing operation, the line speed is updated after the
running trigger processing.
Item Time Remarks
T1 0ms or more Turn on ENCODER A IN (X13) with the shutter opened.
T2 ― Time for marking data creation. It varies depending on the quantity of the setting data.
T3 Max. 10 sec. If ENCODER B IN (X14) does not turn on within 10 seconds from turning on of ENCODER
A IN (X13), time-out error (E607) occurs when TRIGGER IN (X5) is input.
T4 1 to 10 sec.
or
Not specified
(No time-out)
If TRIGGER IN (X5) is not turned on within the setting time-out period from turning on
ENCODER B IN (X14), time-out error (warning E607) occurs.
This time-out can be disabled by setting.
T5 ― Time from when TRIGGER IN (X5) is turned on till when the workpiece comes to the
preset marking position.
T6 0ms or more ENCODER A IN (X13) for the next marking can be accepted after inputting ENCODER B
IN (X14).
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• It is recommended to set the sensors to detect the line speed and the trigger input position as close as possible to
reduce the difference between the detected line speed and the actual line speed at the marking.
ME-LPRH-SM-3