Panasonic LP-RH Series, Setup And Maintenance Manual

Page: 225 / 240

225
Warning: E600 - E799
Errors that notify of that the setting data are incorrect or laser radiation conditions are not met are output as warnings.
Marking cannot be started while any warning of E600 to E699 is active. Laser pumping maintains the state before the
warning.
„
Release method of warning
1. Remove a cause of warning. If the setting is wrong, correct it.
2. In Remote mode, close the inner shutter or input the alarm reset.
As the special case, the following errors will be released automatically.
• E600: The warning is only output while the connection between the LASER STOP IN and OUT COM. 1 is opened
and the warning is released when it is closed.
• E710 - E711: The warning is output during marking and guide laser radiation (except guide pointer operation for
LP-GS052) and it is released when these operations are finished.
• E712 - E717: The warning is output while the cause of error occurs and it is released automatically when the
cause is solved.
• E750 - E783: After output of the warning for 3 seconds, the warning is released.
3. If any warning occurs during marking of files that use the counter, check the counter value before resuming marking.
4. To restart the laser marker operation, make sure that the warning output is turned on, and then open the internal
shutter.
ERROR
CODE
Description Measures *1
E600
LASER STOP IN of the I/O terminal block was
released.
• Connect the LASER STOP IN terminals of the I/O
terminal block.
• Check the status of the safety equipment
connected to the LASER STOP IN terminals.
• Confirm operation logic of connection device.
E601
No marking data were registered to the file
specified.
Set marking data in the file and overwrite.
E603 No data for laser radiation available.
It is not possible to input TRIGGER IN for the file
without valid marking data.
Set “marking on” to more than one object and set its
laser power correction other than 0%.
E604 No data for guide laser radiation available.
To show the masked objects by the guide laser,
enable Guide laser display of the object settings.
E605
E606
The combination of Laser Marker NAVI smart's
version and the laser marker model or version is
wrong.
The function set with Laser Marker NAVI smart
cannot be used for this type of the laser marker.
Use the right version of Laser Marker NAVI smart
corresponding to the laser marker model or version
in use.
E607 *3, *4,
*6
Unable to detect the line speed.
Input of 2 sensors for line speed detection was
wrong.
• Make sure the first sensor in moving direction is
connected to ENCODER A IN and the second
sensor is connected to ENCODER B IN of the I/O
terminal.
• Turn on ENCODER B IN within 10 seconds from
the input of ENCODER A IN.
• Input TRIGGER IN after turning on ENCODER
B IN within the setting time before time-out error
occurs.
ME-LPRH-SM-3