Panasonic FP0 Series, User Manual, Page: 232 / 382

Specifications
FP0
12 − 14
12.5 Specification: Power Supply Unit I/O Link Unit
12.5 Specification: Power Supply Unit I/O Link Unit
12.5.1 FP0 Power Supply Unit (AFP0634)
Item Specification
Input
Rated operating voltage 100 to 240 V AC
p
Operating voltage range
85 to 264 V AC
Frequency
50/60 Hz
Rated frequency 47 to 63 Hz
phase
Single − phase
Inrush current
30 A (0 − p) or less (Cold start)
Leakage current 0.75mA
Holding time 10ms
Output
Rated output
24V ( 5%) DC 0.7A
p
Rated output current
0 to 0.7A
Output ripple 500mV(p − p) or less
Regulation
Over Current Regulation 0.74A
g
Over Voltage Regulation
Available
Life time
20,000h (at 55 C)
12.5.2 FP0 I/O Link Unit
Item Specification
Communication method
Two − line, half − duplex
Synchronous method A synchronization system
Transmission line Twisted cables
(Twisted pair cable or VCTF Min. 0.75mm
2
*2C(JIS))
Transmission distance (Total length) Max. 700m (Twisted pair cable)
Max. 400m (VCTF)
Baud rate 0.5Mbps
Number of I/O points per one I/O
Link unit
64 points
Note)
(Input 32 point + Output 32 point)
I/O map of FP0 I/O Link Unit 32X / 32Y
Interface RS485
Communication error check method CRC (Cyclic Redundancy Check)
Note
This number is the number of points that I/O link is available
through the host PLC and the network MEWNET
− F.
In the case I/O Link error flag is on (valid), Number of I/O points
are 63 points. (Input 31 Output 32 points)