Panasonic FP0 Series, User Manual

Page: 373 / 382

14-131
Error
code
Name
Opera-
tion
status
Description and steps to take
FP0 FP-e FP
Σ
FP-X FP1/FP-M FP2 FP2SH FP10SH FP3
Selec-
table
S-LINK error Occurs only in FP0-SL1
When one of the S-LINK errors (ERR1, 3
or 4) has been deteced,error code E46
(remote I/O (S-LINK) communication
error) is stored.
Selection of operation status using
system register27:
-to continue operation,set K1
-to stop operation,set K0
A
E46
Remote
I/O
commu-
nication
error
Selec-
table
MEWNET-F communication error
A communication abnormally was
caused by a transmission cable or during
the power-down of a slave station.
FP2, FP2SH, and FP10SH:
Check the contents of special data
registers DT90131 to DT90137 and
locate the abnormal slave station and
recover the communication condition.
FP3:
Check the contents of special data
registers DT9131 to DT9137 and locate
the abnormal slave station and recover
the communication condition.
Selection of operation status using
system register27:
-to continue operation,set K1
-to stop operation,set K0
A A A A A
E47
MEW-NET-
F
attribute
error
Selec-
table
In the unit on the slave station, an
abnormallty such as:
-missing unit
-abnormal intelligent unit was detected.
FP2, FP2SH, and FP10SH:
Check the contents of special data
registers DT90131 to DT90137 and
locate the abnormal slave station and
recover the slave condition.
FP3:
Check the contents of special data
registers DT9131 to DT9137 and locate
the abnormal slave station and recover
the slave condition.
Selection of operation status using
system register28:
-to continue operation,set 1
-to stop operation,set 0
A A A A
E49
Expansion
unit power
supply
sequence
error
Stops
The power supply for the expansion unit
was turned on after the control unit.
Turn on the power supply for the
expansion unit at the same time or
before the control unit is turend on.
A
A:Available