Omron CS1W-SLK11-21 - 06-2004, Manual

Page: 96 / 202

79
CX-Programmer Procedures Section 4-12
2. Select PLC and then Open . When connected, the display will change as
follows:
Select PLC and then Open to reconnect if disconnected.
Reading and Transferring Data Link Tables
Read the data link tables that have been created and then transfer them to all
the nodes participating in the data links.
Reading Data Link Tables
1,2,3... 1. Start the CX-Net and select Data Link and then Setup . If connected locally
(i.e., directly to the PLC), the Data Link Setup (Local) Dialog Box will ap-
pear.
If connected remotely (i.e., through a network), the Data Link Setup (SYS-
MAC LINK) Dialog Box will appear.
2. Select SYSMAC LINK and then click the OK button. The following dialog
box will appear.
Turns green
Shows connection status and PLC mode.
Select this button to display the
Communications Units mounted on
the PLC
.
Open the data link table file (*.sl3). Refer to Data
Link Setup (SYSMAC LINK) Dialog Box Func-
tions below for other button functions.