Omron CS1W-SLK11-21 - 06-2004, Manual

Page: 36 / 202

19
Cable Connections Section 2-4
Note Up to 16 CPU Bus Units may be installed to on PLC.
2-4 Cable Connections
SYSMAC LINK Units can be connected with either coaxial cable or optical
fiber cable. This section describes the procedures required to connect these
cables.
2-4-1 Coaxial Units
This section describes the procedures required to connect SYSMAC LINK
Units with coaxial cables.
Required Components
1,2,3... 1. Coaxial cable and Connectors:
Use the 5C-2V coaxial cable designed for indoor use. Install connectors on
each end of the cable. Cables must be continuous. No intervening cable
connectors or breaks are permitted. OMRON recommends the following
cables and connectors.
2. F Adapters (C1000H-CE001):
Coaxial cables are connected to the SYSMAC LINK Units via F Adapters.
One F Adapter is included as an accessory with SYSMAC LINK Units that
use coaxial cables (CV500-SLK21).
3. Terminator (C1000H-TER01):
Two Terminator units (sold separately) are required, one for the F Adapter
at each end of the network.
CPU Rack
SYSMAC LINK Units can be mounted to the
2/3/5/8/10 slots shown in the diagram on the right.
Mount to up to four
of these slots.
CPU Rack
(CS1W-BC103, CS1W-BC083, CS1W-BC053, CS1W-BC033, CS1W-BC023)
2/3/5/8/10 slots
CS-series Expansion Racks
(CS1W-BI108, CS1W-BI083, CS1W-BI053, CS1W-BI033)
CS1 Expansion Rack
SYSMAC LINK Units can be mounted to the
3/5/8/10 slots shown in the diagram on the right.
C200H Expansion I/O Rack
SYSMAC LINK Units cannot be
mounted to Expansion I/O slots.
3/5/8/10 slots
C200H Expansion Rack
PS: Power Supply Unit
CPU: CPU Unit