Omron CS1W-SLK11-21 - 06-2004, Manual

Page: 27 / 202

10
Data Link Procedures Section 1-5
Using a Personal Computer as a Node
Note (1) The CS-series SYSMAC LINK Units cannot be directly connected to
SYSMAC Support Software.
(2) For further details about the CX-Programmer, refer to the CX-Program-
mer Operation Manual.
(3) The CX-Net in the CX-Programmer cannot set data link tables for the
C200H-SLK21 or C1000H-SLK21. Refer to
9-3 Using the C200H-SLK21
or C1000H-SLK21
for details.
1-5 Data Link Procedures
1-5-1 Manually Setting Data Links
When the data link mode is set for manual data link table creation, the data
link tables can be input using the CX-Net within the CX-Programmer. Use the
following procedure.
1,2,3... 1. Install and wire the Units.
2. Prepare for communications.
Software External
appearance
Model
CX-Programmer WS02-CX @@ E
IBM PC/AT or compatible
+
SYSMAC LINK
Support Board
Setting data link tables
CX-Net in
CX-Programmer
Contents Method Nodes Page
a. Mount the Units to
the PLCs.
--- All nodes 18
b. Wire the Network. --- All nodes 19
c. Connect terminat-
ing resistance
Use C100H-TER01
Terminator. Coaxial systems only.
End nodes on the net-
work: Connect Termi-
nator
Contents Method Nodes Page
a. Set the unit num-
ber.
Use the front rotary
switches. CS-series, CVM1, and
CV-series PLCs only 18
b. Set the node
address.
Use the front rotary
switches. All nodes