Omron CS1W-SLK11-21 - 06-2004, Manual

Page: 30 / 202

13
Data Link Procedures Section 1-5
4. Connect the Programming Device.
5. Create I/O tables.
6. Set the parameters for automatic data link creation.
7. Start the data links.
Note Data link Start/Stop Bit (N= unit number):
CS Series: Word 0 of D 100
×
N
8. Stop the data links.
Note (a) Data link Start/Stop Bit (N= unit number):
CS Series: Word 0 of D 100
×
N
(b) The data links will not start if there is an error in the data link ta-
bles in the startup node. Data links can be started and stopped
using the CX-Net within the CX-Programmer.
Contents Method Nodes Page
Connect the Program-
ming Console or Sup-
port Software. Use the special con-
nection cable. CS-series, CVM1, and
CV-series PLCs only 8
Contents Method Nodes Page
Create the I/O tables. Use the SYSMAC
Support Software or
Programming Con-
sole. CS-series, CVM1, and
CV-series PLCs only ---
Contents Method Nodes Page
a. Set the data link
mode to auto-
matic.
Use the SYSMAC
Support Software or
Programming Con-
sole. Data link startup node
only
The node that is used to
start the data link is
called the startup node.
It is necessary to decide
beforehand which node
will be the startup node.
45
b. Set the number of
data link words.
Data link startup node
only
Contents Method Nodes Page
Start the data links. Switch the Data link
Start/Stop Bit (listed
below) from OFF to
ON using either the
Programming Device,
or the user program. Data link startup node
(The Start Bit can be
turned ON in more
then one node to
make sure the data
links start even when
the startup node is
down.)
55, 67
Contents Method Nodes Page
Stop the data links. Switch the Data link
Start/Stop Bit (listed
below) from OFF to
ON using either the
Programming Device,
or the user program. Any node that is active
in the data link 55, 67