Omron CS1W-SLK11-21 - 06-2004, Manual

Page: 158 / 202

141
Error Log Section 8-2
0117
Hex Internal buffer full Command block
Bits 0 to 7:
Source node address
Bits 8 to 14:
Source Network address
Bit 15:
OFF
Response block
Bits 0 to 7:
Destination node address
Bits 8 to 14:
Destination Network
address
Bit 15:
ON
(1st byte: bits 8 to 15;
2nd byte, bits 0 to 7)
Increase number of retries or
reconfigure system to distrib-
ute load. No
0118
Hex Illegal packet discarded Check for nodes sending ille-
gal packets. Yes
0206
Hex Number of participating nodes
decreased (local node still partic-
ipating) Network
parameters
maximum
node address Number of
non-partici-
pating nodes Check network parameters,
node participation, cables,
and terminating resistance. No
0207
Hex Number of participating nodes
decreased (local node not partic-
ipating) No
0208
Hex Polling node changed Address of
previous poll-
ing node Address of
new polling
node Check previous polling node. No
0209
Hex Network parameter disagree-
ment error 00 Hex Address of
polling node Using the CX-Net, check net-
work parameters. Yes
020C
Hex Time out with token 00 Hex Error status
(see note) Check network parameters,
node participation, cables,
and terminating resistance. No
0210
Hex Communications controller send
error 00 Hex Error status
(see note) Replace the SYSMAC LINK
Unit. Yes
0211
Hex Duplicate address error 00 Hex Local node
address Set so that each node
address is used only once
within the same Network. No
0214
Hex Node address setting error Not specified Check the node address set-
tings and correct them. Yes
0216
Hex Backup power supply error (Opti-
cal Units only) 00 Hex fixed Backup
power sup-
ply error dis-
tinction:
01 Hex: OFF
to ON
02 Hex: ON
to OFF Check the status of the
backup power supply and
power supply cables. Yes
021A
Hex Set table logic error 00 Hex 01 Hex: Net-
work param-
eters
02 Hex:
Data link
tables
03 Hex:
Routing
tables Remake and set the appropri-
ate data. Yes
021B
Hex Hardware error 00 Hex Error status
(see note) Replace the SYSMAC LINK
Unit. No
Error
code
Contents Detail code Correction Written to
EEPROM
1st byte 2nd byte