Omron CS1W-SLK11-21 - 06-2004, Manual

Page: 28 / 202

11
Data Link Procedures Section 1-5
3. Turn ON the power to the PLC.
4. Connect the Programming Device.
5. Create I/O tables.
6. Set the data link mode.
Note Be sure that the data link mode in the data link parameters in the DM
Area is set to 00 when using manually set data links.
7. Register the data link tables by making the following settings for each
node.
Note Offsets are used to control where data is placed within the receive ar-
ea.
Contents Method Nodes Page
Turn ON the power to
the PLC. --- All nodes ---
Contents Method Nodes Page
Connect the Program-
ming Console or Sup-
port Software. Use the special con-
nection cable. CS-series, CVM1, and
CV-series PLCs 8
Contents Method Nodes Page
Input the I/O tables. Use the SYSMAC
Support Software or
Programming Con-
sole. CS-series, CVM1, and
CV-series PLCs only ---
Contents Method Nodes Page
Set data link mode to
manual. Use the SYSMAC
Support Software or
Programming Con-
sole. Data link startup node
only
The node that is used
to start the data link is
called the startup
node. It is necessary
to decide beforehand
which node will be the
startup node.
45
Contents Method Nodes Page
First data link status word Use the CX-Net
within the CX-Pro-
grammer. All nodes within the
network
Delete from the data
link tables all nodes
that are not in a data
link.
46, 67
Data link nodes
Area
1 First data link sta-
tus words
Numbers of data
link words
Area
2 First data link sta-
tus words
Numbers of data
link words