Omron CS1W-SLK11-21 - 06-2004, Manual

Page: 156 / 202

139
Error Log Section 8-2
0012
Hex CPU Unit memory error 01 Hex: Read
error
02 Hex: Write
error 01 Hex:
Data link
table
02 Hex: Net-
work param-
eters
03 Hex:
Routing
table
04 Hex: PLC
Setup Area Set the appropriate data. Yes
0013
Hex CPU Unit write-protected Release the CPU Unit write
protection. Yes
0101
Hex Transmission failed; local node
not in Network Command block
Bits 0 to 7:
Source node address
Bits 8 to 14:
Source Network address
Bit 15:
OFF
Response block
Bits 0 to 7:
Destination node address
Bits 8 to 14:
Destination Network
address
Bit 15:
ON
(1st byte: bits 8 to 15;
2nd byte, bits 0 to 7)
Refer to page 8-1-1 Error Indi-
cations and place the local
node into Network.
No
0103
Hex Transmission failed; retry count
exceeded Using the CX-Net or FINS
commands, run echoback
tests and check operating
environment if errors occur. No
0104
Hex Transmission failed; maximum
number of frames exceeded. Reduce the number of events
per communications cycle or
increase the maximum num-
ber of network parameter
frames. No
0105
Hex Transmission failed; node
address incorrect Check node address settings
to be sure they are within
range and unique. No
0106
Hex Transmission failed; redundant
node address Correct node addresses so
that they are unique within the
same Network. No
0107
Hex Transmission failed; destination
node not in Network Refer to 8-1-1 Error Indica-
tions and place destination
node into Network.
No
0108
Hex Transmission failed; specified
Unit does not exist Check the unit address and
unit number of destination. No
Error
code
Contents Detail code Correction Written to
EEPROM
1st byte 2nd byte