NXP Semiconductors K22F series, Reference Manual, Page: 873 / 1407

38.3.1 Status and Control register (PDBx_SC)
Address: 4003_6000h base + 0h offset = 4003_6000h
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
R
0
LDMOD
PDBEIE
0
W
SWTRIG
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
DMAEN
PRESCALER TRGSEL
PDBEN
PDBIF
PDBIE
0
MULT
CONT LDOK
W
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
PDBx_SC field descriptions
Field Description
31–20
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
19–18
LDMOD
Load Mode Select
Selects the mode to load the MOD, IDLY, CH n DLY m , INT x , and PO y DLY registers, after 1 is written to
LDOK.
00 The internal registers are loaded with the values from their buffers immediately after 1 is written to
LDOK.
01 The internal registers are loaded with the values from their buffers when the PDB counter reaches
the MOD register value after 1 is written to LDOK.
10 The internal registers are loaded with the values from their buffers when a trigger input event is
detected after 1 is written to LDOK.
11 The internal registers are loaded with the values from their buffers when either the PDB counter
reaches the MOD register value or a trigger input event is detected, after 1 is written to LDOK.
17
PDBEIE
PDB Sequence Error Interrupt Enable
Enables the PDB sequence error interrupt. When this field is set, any of the PDB channel sequence error
flags generates a PDB sequence error interrupt.
Table continues on the next page...
Chapter 38 Programmable Delay Block (PDB)
K22F Sub-Family Reference Manual, Rev. 4, 08/2016
NXP Semiconductors 873