NXP Semiconductors K22F series, Reference Manual, Page: 349 / 1407

RCM_SSRS0 field descriptions (continued)
Field Description
Indicates a reset has been caused by a loss of external clock. The MCG clock monitor must be enabled
for a loss of clock to be detected. Refer to the detailed MCG description for information on enabling the
clock monitor.
0 Reset not caused by a loss of external clock.
1 Reset caused by a loss of external clock.
1
SLVD
Sticky Low-Voltage Detect Reset
If PMC_LVDSC1[LVDRE] is set and the supply drops below the LVD trip voltage, an LVD reset occurs.
This field is also set by POR.
0 Reset not caused by LVD trip or POR
1 Reset caused by LVD trip or POR
0
SWAKEUP
Sticky Low Leakage Wakeup Reset
Indicates a reset has been caused by an enabled LLWU modulewakeup source while the chip was in a
low leakage mode. In LLS mode, the RESET pin is the only wakeup source that can cause this reset. Any
enabled wakeup source in a VLLSx mode causes a reset.
0 Reset not caused by LLWU module wakeup source
1 Reset caused by LLWU module wakeup source
14.2.7 Sticky System Reset Status Register 1 (RCM_SSRS1)
This register includes status flags to indicate all reset sources since the last POR, LVD or
VLLS Wakeup that have not been cleared by software. Software can clear the status flags
by writing a logic one to a flag.
Address: 4007_F000h base + 9h offset = 4007_F009h
Bit 7 6 5 4 3 2 1 0
Read 0 0 SSACKERR SEZPT SMDM_AP SSW SLOCKUP SJTAG
Write w1c w1c w1c w1c w1c w1c
Reset
0 0 0 0 0 0 0 0
RCM_SSRS1 field descriptions
Field Description
7
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
6
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
5
SSACKERR
Sticky Stop Mode Acknowledge Error Reset
Table continues on the next page...
Chapter 14 Reset Control Module (RCM)
K22F Sub-Family Reference Manual, Rev. 4, 08/2016
NXP Semiconductors 349