NXP Semiconductors K22F series, Reference Manual, Page: 531 / 1407

WDOG_STCTRLH field descriptions (continued)
Field Description
0
WDOGEN
Enables or disables the WDOG’s operation. In the disabled state, the watchdog timer is kept in the reset
state, but the other exception conditions can still trigger a reset/interrupt. A change in the value of this bit
must be held for more than one WDOG_CLK cycle for the WDOG to be enabled or disabled.
0 WDOG is disabled.
1 WDOG is enabled.
24.7.2 Watchdog Status and Control Register Low
(WDOG_STCTRLL)
Address: 4005_2000h base + 2h offset = 4005_2002h
Bit 15 14 13 12 11 10 9 8
Read
INTFLG Reserved
Write
Reset
0 0 0 0 0 0 0 0
Bit 7 6 5 4 3 2 1 0
Read
Reserved
Write
Reset 0 0 0 0 0 0 0 1
WDOG_STCTRLL field descriptions
Field Description
15
INTFLG
Interrupt flag. It is set when an exception occurs. IRQRSTEN = 1 is a precondition to set this flag. INTFLG
= 1 results in an interrupt being issued followed by a reset, WCT later. The interrupt can be cleared by
writing 1 to this bit. It also gets cleared on a system reset.
Reserved This field is reserved.
NOTE: Do not modify this field value.
24.7.3 Watchdog Time-out Value Register High (WDOG_TOVALH)
Address: 4005_2000h base + 4h offset = 4005_2004h
Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Read
TOVALHIGH
Write
Reset
0 0 0 0 0 0 0 0 0 1 0 0 1 1 0 0
WDOG_TOVALH field descriptions
Field Description
TOVALHIGH Defines the upper 16 bits of the 32-bit time-out value for the watchdog timer. It is defined in terms of cycles
of the watchdog clock.
Chapter 24 Watchdog Timer (WDOG)
K22F Sub-Family Reference Manual, Rev. 4, 08/2016
NXP Semiconductors 531