NF FRA5097, Instruction Manual

Page: 95 / 192

4.6 Display setting
FRA5097 4-21
！
CAUTION
It can happen that the data read out from USB
flash drive
cannot be loaded
into the memory due to insufficient capacity of the memory, when the data
volume of the file to be read out from the USB
flash drive
is too large. Take
the following measures when the memory capacity is insufficient for loading
the data:
1) Delete unnecessary data in the mass memory.
2) If you have any data that have not yet been stored in the USB
flash drive
since the data have just been taken, and if those data are unnecessary for
you, press the function key [DELETE CUR.TAG] in the menu [Memory]
to delete the data.
If you find you cannot yet load the data from the floppy disk even after you
have taken the measures above, record and store into the permanent memory all
those data that are in the mass memory and also those data that have not yet
been stored in either the mass memory or the permanent memory, which have
been left as measured. Then, switch off the power supply of the FRA5097
and switch it on again to load the data from the USB
flash drive
.