2-4 System Configuration
The following sections provide information and guidelines about the jumpers
and their factory settings.
Note:
Jumpers are set correctly at the factory for the
system configuration. If a jumper change is required, change
only the setting for that condition.
System Board Configuration Settings
System board jumpers enable you to configure your system for a particular
system requirement.
You may need to change the system board settings to:
configure the system for a graphics board by disabling the onboard VGA
restore the CMOS settings to their factory state
prepare the system for the installation of a slower processor
configure the system to power on when the power cable is plugged in
instead of when the power button is pushed.
!
CAUTION
Jumpers are set correctly at the factory for your
configuration.
If your system requires a jumper change, change only the
setting for that condition. Otherwise, keep the jumpers at
their factory settings.
The following figure shows jumper locations on the system board.
Locating System Board Jumpers
A – JVGA1 (VGA Mode)
C – JP1 (Power On Mode)
B – JBAT1 (CMOS Clear)
Summary of Contents for POWERMATE ES 5200 - SERVICE
