NEC POWERMATE ES 5200 - SERVICE, Service Manual

Page: 128 / 306

Disassembly and Reassembly 3-45
4.
Use the two handles on the board to carefully slide the system board partway
into the chassis, along the rail guides.
Locating System Board Rail Guides — Minitower
A – System Board C – Rail Guides
B – Handles/Rails
5. Stop sliding the board when the edge of the system board aligns with the
hinged edge of the chassis floor.
6.
Slowly close the chassis floor to slide the board into the connector on the
riser board.
!
CAUTION
If the board does not slide in when you attempt to close the
chassis floor, pull the board out of the chassis a bit, check
the alignment, and correct as necessary. Close the chassis
floor.
7.
Close the chassis floor (see “Closing the Chassis Floor”).
8.
Place the system unit upright and swivel the feet out, perpendicular to the
system unit.
9.
Replace the left side cover (see “Replacing the Minitower Side Covers”).