NEC POWERMATE ES 5200 - SERVICE, Service Manual

Page: 117 / 306

3-34 Disassembly and Reassembly
To install a 3 1/2-inch device in the 3 1/2-inch accessible device bay, proceed as
follows.
1.
Follow the preinstallation instructions that come with your device, such as
setting jumpers.
2.
Remove the system unit cover (see “Removing the Small Desktop or
Desktop Cover”).
3. Remove the front panel (see “Removing the Front Panel — Desktop”).
4. Remove the metallic breakaway shield covering the device bay.
5. If you are installing a diskette drive, remove the device bay cover from the
front panel by squeezing the locking tabs together (see the following figure).
Removing the 3 1/2-Inch Device Bay Cover — Desktop
6. Insert the device, connector end first, into the bay. Align the screw holes in
the drive with the holes in the drive bracket.
7.
Insert and tighten the two screws to secure the drive in the bracket (see the
figure in “Removing the Additional 3 1/2-Inch Device — Desktop”).
8.
Connect the device cables.
9.
Replace the front panel (see “Replacing the Front Panel — Desktop”).
10.
Replace the system unit cover (see “Replacing the Small Desktop or
Desktop Cover”).
11. Run the Setup program to set the new configuration (see “CMOS Setup
Utility” in Section 2).
Removing a 3 1/2-Inch Hard Drive — Minitower
To remove a 3 1/2-inch internal hard drive from the system, proceed as follows.
1.
Remove the left side cover (see “Removing the Minitower Side Covers”).
2.
Remove the top cover (see “Removing the Minitower Top Cover”).