NEC POWERMATE ES 5200 - SERVICE, Service Manual

Page: 137 / 306

3-54 Disassembly and Reassembly
Releasing the Celeron or Pentium III Processor Cartridge
A – Retention Mechanism D – Retaining Bar
B – Tabs E – System Board
C – Processor Cartridge
7.
Set the cartridge down on an antistatic surface or store it in an antistatic bag.
!
CAUTION
Before picking up the processor cartridge, reduce static
discharge by touching the metal frame of the system unit.
8. Install the upgrade processor (see “Installing the Celeron or Pentium III
Upgrade Processor Cartridge” or “Installing the Pentium II Upgrade
Processor Cartridge”).
Installing the Celeron or Pentium III Upgrade Processor Cartridge
Install a Celeron or Pentium III upgrade processor cartridge as follows.
Note:
NEC CSD recommends that you print out or write
down your current CMOS Setup parameters and store the
information in a safe place before installing a processor.
Note:
If you are upgrading from a Pentium II processor
to a Celeron or Pentium III processor, you must obtain a
retaining bar to place over the processor cartridge. See
Section 9, “NEC CSD Information Services,” for information
on contacting NEC CSD for this part.
1. If you are replacing the processor cartridge currently in your system, remove
the cartridge (see “Removing the Celeron or Pentium III Processor
Cartridge”).