System Configuration 2-5
Setting Onboard VGA
If you add a graphics board to your system, you must disable the onboard VGA
by changing the jumper setting on block JVGA1 (see the following table).
Onboard VGA Jumper Settings
JVGA1
Function
1-2
Enables onboard VGA.
2-3
Disables onboard VGA.
Clearing CMOS
If you need to manually reset your CMOS settings to their factory state, change
the jumper setting on block JBAT1 after the system has been unplugged. The
following table lists the jumper settings, and the function of each setting. Move
the jumper back to pins 1-2 (to keep future CMOS changes) after waiting
approximately five seconds.
CMOS Clear Jumper Settings
JBAT1
Function
1-2
Keeps CMOS changes.
2-3
Clears CMOS changes.
Setting the Power On Mode
Your system can be jumpered to start up in two ways:
when the power button is pressed, or
when the power cable is connected (“Immediate Boot Up”).
To change the way your system starts up, change the jumper setting on block
JP1. The following table lists the jumper settings, and the function of each
setting.
Note:
If a Power On mode is set in the CMOS Setup
Utility, it overrides the JP1 jumper setting.
Power On Mode Jumper Settings
JP1
Function
1-2
Boot up when power button is pressed.
none
Immediate boot up when power cable is connected.
Summary of Contents for POWERMATE ES 5200 - SERVICE
