NEC POWERMATE ES 5200 - SERVICE, Service Manual

Page: 113 / 306

3-30 Disassembly and Reassembly
Internal Hard Drive Removal and Installation
The following sections describe how to remove and install a 3 1/2-inch internal
hard drive. Procedures for small desktop, desktop, and minitower systems are
provided.
Removing a 3 1/2-Inch Hard Drive — Small Desktop
The small desktop system has an internal hard drive bay located near the top
front of the chassis. You can upgrade the system by replacing the existing hard
drive with a higher capacity drive available from NEC CSD.
To replace a 3 1/2-inch internal hard drive, proceed as follows.
1. Remove the system unit cover (see “Removing the Small Desktop or
Desktop Cover”).
2.
Label the IDE device signal and power cables connected to the drive and
then disconnect them.
3.
Remove the two screws securing the internal hard drive bracket to the braces
on the top of the chassis (see
A in the following figure).
4.
Lift the internal hard drive bracket and hard drive off of the chassis.
5.
Remove the screws securing the drive to the bracket.
6. If you are installing a new hard drive, see “Installing a 3 1/2-Inch Hard
Drive — Small Desktop.”
Internal Hard Drive Screws — Small Desktop
A – Bracket Screw C – Hard Drive Screws
B – Hard Drive D – Chassis Braces