NEC POWERMATE ES 5200 - SERVICE, Service Manual

Page: 108 / 306

Disassembly and Reassembly 3-25
Installing a Diskette Drive — Minitower
Use the following procedure to install a diskette drive in a 3 1/2-inch accessible
drive bay of the minitower system.
1. Follow the preinstallation instructions that come with your drive, such as
setting jumpers and switches.
2.
Remove the left side cover (see “Removing the Minitower Side Covers”).
3.
Remove the front panel (see “Removing the Front Panel — Minitower”).
4.
From the front of the system, slide the drive, connector end first, into the
drive bay. Slide it in far enough for access to the connectors at the rear of the
drive. If necessary, remove the top cover for better access to the drive
connectors (see “Removing the Minitower Top Cover”).
5. Connect the drive cables.
6.
If necessary, slide the drive toward the back of the chassis until it snaps in
place.
7.
Secure the drive in the bay with two screws (see the figure in “Removing a
Diskette Drive — Minitower”).
8.
Replace the front panel (see “Replacing the Front Panel — Minitower”).
9.
If removed, replace the top cover (see “Removing the Minitower Top
Cover”).
10.
Replace the left side cover (see “Replacing the Minitower Side Covers”).
11.
Run the Setup program to set the new configuration (see “CMOS Setup
Utility” in Section 2).