ND-70348 (E)
CHAPTER 4
Page 676
Revision 3.0
ANPDN
ANPDN: Assignment of Numbering Plan for NDM
1. General
This command is used to assign the minimum number of digits needed to determine the service (Telephone
Number) which is required to the first digit received (pre-translation). The data assigned on this command is
written in the Network Data Memory (NDM) of the Network Control Node (NCN), updating the NDM at each
Local Node (LN).
2. Precautions
1.
This command is used for the Business Application.
2.
The applicable tenant number (TN) range is designated by the ASYD command, SYS 1, INDEX 8.
If the numbering plan is common for all tenants (ASYDN, SYS1, INDEX 800, bit2=1), assign TN param-
eter as “1” for all tenants.
3.
The system data assignment (ASYDN, SYS 1, INDEX 514, bit0=1) is needed to provide the Network Data
Memory (NDM).
4.
For more detail, see the “Netfusing System Manual”.
3. Data Entry Instructions
TENANT
NUMBER
(TN)
1st DIGIT CODE
(1st DC)
CONNECTION
STATUS INDEX
(CI)
N/H/B
NUMBER OF
NECESSARY DIGITS
(NND)
MAXIMUM 6 DIGITS
BUSY LAMP FIELD
DISPLAY ACTIVATED ON
A ATT
(BLF)
0/1
0
NND
The primarily analyzed digits, prior to the ASPAN command to assign
different number of digits for this, assign minimum number of digits
in this parameter.
1st DC
The first digit of access code for Tele-
phone Number.
(0-9,*,#)
CI
The status of the “1st DC” dialed
N= Normal(Idle)
H= Hooking
B= Busy
BLF
Not used. (Fixed to 0)