ND-70348 (E)
CHAPTER 4
Page 433
Revision 3.0
ALRNN
6
TCL
Trunk Class
Specify the kind of trunk
1 = DDD Line
2 = FX
3 = WATS Line
4 = Tie Line/Announcement Trunk
5 = CCSA
6 = Toll Terminal
7 = CAS Line
8 = Paging
9 = Code Call Trunk
10 = Dictation Trunk
11 = General Paging Trunk
12 = Radio Paging Trunk
13 - 31 = Not used
7
L/T
Line/Trunk Identification
0
= Not used (Line)
1
= Trunk
1
1
1
1
1
This data should always
be assigned as “1.”
8
RLP
Trunk Release Pattern
0
= Calling Party Release (Outgoing only)
1
= Not used
2
= First Party Release (either station or trunk side)
3
= Not used
Normally assign data
“2”
9
TQ
Outgoing Trunk Queuing
0
= Out of Service
1
= In Service
10
SMDR
Detailed Billing Information
0
= SMDR Out of Service
1
= SMDR In Service (ORT required for receiving all dialed
digits
11
TD
Toll Denial Battery Reversal
0
0
0
0
0
Always assign data “0.”
12
DR
Distinctive Ringing Pattern
This parameter designates whether distinctive ringing will
be provided for an incoming call.
0
= Distinctive Ringing is not required
(ASYD, SYS 3, Index 3, Bit 0=0)
1
= Distinctive Ringing is required
(ASYD, SYS 3, Index 3, Bit 0=1)
13
AC
Flexible Routing Pattern Designation
When outgoing route selection pattern number is to be de-
termined by the AFRS command, “1” is to be assigned if the
Access Code is included in the Number Pattern Code
(NPC).
0
= When flexible routing is executed, numbers are translated
excluding the Access Code
1
= When flexible routing is executed, numbers are translated
including the Access Code
This data is valid for
dummy routes. Assign
data “1” for the dummy
route.
14
TNT
Tenant Number Check
0
= Tenant number check is not required in trunk selection.
This data should always
be assigned as “0.”
LOGICAL ROUTE (LGRT) 1-899
REMARKS
FUSION POINT CODE (FPC) 1-253
ROUTE NUMBER (RT) 1-255
