ND-70348 (E)
CHAPTER 4
Page 652-1
Revision 5.0
APID
APID: Assignment of PKG of IP Data for LDM
1. General
This command is used to assign IP address of IPELC card and the DRS Server. The data assigned by this
command is written in the Local Data Memory (LDM).
2. Precautions
1.
The following three parameters, DRS IP Address (Secondary), RAS Port No., and PROTIMS/RTP Starting
Port No. are optionally assigned when check box for each parameter is clicked.
2.
It is required to initialize the IPELC card to validate the data assigned by this command.
3.
This command is available since Release 10 software enhancement.
4.
The parameters of User Priority, Virtual LAN Identifier, VLAN IPELC IP Address, and VLAN Netmask
are available since Release 11 software enhancement.
3. Data Entry Instructions
Note 1:
For “G”, either “00”, “04”, “08”, “12”, “16”, or “20” can be entered.
Note 2:
The three parameters, DRS IP Address, RAS Port No., and PROTIMS/RTP Starting Port No. are optionally
used. Assign each data if required.
DRS IP
ADDRESS
(PRIMARY)
IPELC PKG
LENS
MG
U
G
IPELC
DEFAULT
GATEWAY IP
ADDRESS
IPELC IP
ADDRESS
IPELC
NETMASK
DRS IP
ADDRESS
(SECONDARY)
RAS PORT
No.
[0-65535]
PROTIMS/
RTP
STARTING
PORT No.
[0-65535]
IPELC NETMASK
Net Mask of the IPELC IP address.
IPELC PKG LENS
Designate the LENS (Line Equipment Number)
of target IPELC circuit card [5 digits].
Note 1
PROTIMS/RTP STARTING PORT No.
When the data is “0”, it is dealt with default
value “5000”. [0-65535]
Note 2
Enter the IP address of secondary used
DRS Server, if required.
Note 2
DRS IP ADDRESS (SECONDARY)
Enter the IP address of mainly used DRS Server.
DRS IP ADDRESS (PRIMARY)
When the data is “0”, it is dealt with default value “3456”. This
data is used corresponding to mobile computing. [0-65535]
Note 2
RAS PORT No.
