ND-70348 (E)
CHAPTER 4
Page 449
Revision 3.0
ATRK
ATRK: Assignment of Trunk Data
1. General
This command is used to assign the trunk data as the LENS, Trunk Route number (RT) and Trunk number (TK).
2. Precautions
1.
The trunk route (RT) is composed of the trunks (TK). The trunk is categorized into two kinds; such as the
external trunk and the internal trunk.
(a) The External trunk is an interface to a different node.
(b) The Internal trunk is a common device which is accessed by a station or an external trunk.
2.
The attribute data configuring the external trunk route should be assigned by the ARTD command in ad-
vance.
3.
The applicable number of external trunk routes (quantity) is designated by the ASYD command, SYS1,
INDEX65.
4.
When trunk data has been assigned by this command, the trunk is in the “Make Busy” state. The MBTK
command is used for the Make Busy control.
5.
The maximum number of Attendant Console is designated by the ASYD command, SYS1, INDEX9.
6.
When an attendant console is assigned, enter the followings additionally;
(a) RSC : enter “0” normally
(b) SFC : enter “0” normally
(c) TN : tenant number which is handled by the ATT.
Note:
(When less than 10 tenants, press the Enter key to jump to WRT? field.)
Note:
The first tenant number entered in TN parameter becomes the tenant number of the Attendant Console.
7.
When you enter the LENS, you should consider the port appearance of the trunk circuit card, which is
shown in Figure 4-19 through Figure 4-27.
ATRK for DTI(E1)
: Figure 4-19
ATRK for CCT(E1)
: Figure 4-20
ATRK for PRT(30B+D) : Figure 4-21
ATRK for 16COT
: Figure 4-22
ATRK for 8COT
: Figure 4-23
ATRK for RST
: Figure 4-24
ATRK for ATI
: Figure 4-25
ATRK for 4DAT
: Figure 4-26
ATRK for CFT
(3party conference)
: Figure 4-27
Moreover, the Group number (G) of LENS and the PCM highway running is illustrated in Figure 4-18 on
the next page.
