ND-70348 (E)
CHAPTER 4
Page 595
Revision 3.0
ACDN
ACDN: Assignment of Number of Digits for Consecutive Dialing Data
1. General
This command is used to assign the number of digits to be added to the access code of a distant office that has
been assigned via the AMND command.
2. Precautions
1.
The ARTD command is to be used to assign data "1" in the parameter CD prior to the operation of this
command. It is also necessary to assign the distant office code via AMND command prior to assigning the
data for ACDN.
2.
As far as tenants are concerned, the same conditions apply as the AMND command. If the numbering plan
is common for all tenants (ASYD, SYS1, INDEX 93, bit6=1), assign the TN parameter 1 for all tenants.
3.
The applicable tenant number (TN) range is designated by the ASYD command, SYS 1, INDEX 8.
3. Data Entry Instructions
TENANT NUMBER
(TN)
DESTINATION CODE
(DC)
MAXIMUM 10 DIGITS
NUMBER OF DIGITS OF
CONSECUTIVE DIALING
(CDN)
REMARKS
Enter the number of digits to be transmitted after
the dialed number (Destination number).
CDN
DC
Enter the "access code + area/office code" (or its
element) to be specified the necessary digits.
