ND-70348 (E)
CHAPTER 4
Page 253
Revision 3.0
ASTPN
ASTPN: Assignment of Signal Translation Pattern for NDM
1. General
This command is used to assign the Incoming/Outgoing Selection Translation Pattern Number (PNI/PNO) for
incoming or outgoing trunk route in Netfusing system. The data assigned by this command is written in the Net-
work Data Memory (NDM) of the Network Control Node (NCN), updating the NDM at each Local Node (LN).
2. Precautions
1.
The PNI/PNO is an intermediate parameter to assign additional number (and skip digits) by the AISPN/
AOSPN command.
(a) When IC/OG=I (Incoming) is entered, the additional number is assigned by the AISPN command.
(b) When IC/OG=O (Outgoing) is entered, the additional number and skip digits are assigned by the
AOSPN command.
2.
The transmit number translation of the OGC/OGCA method outgoing calls are done by ASTPN/AOSPN
command. Since the additional number and skip digits can be assigned by the AOPRN /AADCN command
for LCR/LCRS method, the ASTPN/AOSPN command may not be required.
3.
The system processes ASTPN/AISPN command prior to the numbering plan data. Thus, if the LCR access
code is added to the received numbers by the ASTPN/AISPN command, the system processes the LCR re-
lated command such as ASPAN/AFRSN /AOPRN.
4.
The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8. Enter
the tenant number in which this command effects. If data of this command is common for all tenants
(ASYDN command, SYS1, INDEX800, bit4,5=1), assign TN parameter as data “1” for all tenants.
3. Data Entry Instructions
PNI appears when IC/OG=I is entered. Enter any number with
a range from 1 to 15.
I=Incoming
O=Outgoing
PNI
IC/OG
KIND OF
ASSIGNMENT
(IC/OG)
I/O
TENANT
NUMBER
(TN)
LOGICAL
ROUTE
NUMBER
(LGRT)
1-899
INCOMING SELECTION
TRANSLATION
PATTERN NUMBER
(PNI)
1-15
OUTGOING SELECTION
TRANSLATION
PATTERN NUMBER
(PNO)
1-15
I
1
0
0
1
1
PNO appears when IC/OG=O is entered. Enter any number
with a range from 1 to 15.
PNO