NAC Image Technology MC-529, User Manual

Page: 87 / 180

(00235) 3-35
3.2.14.7.3 EVENT(A)
Figure 3-43 shows how to switch modes with the J-PAD3 during EVENT(A) recording (top of the figure)
and saving in the memory (bottom of the figure). EVENT (A) refers to event recording in the AUTO mode.
The sequences for setting four memory segments and for EVENT(A) recording to all of the memory
segments are shown below.
The memory should be empty before recording is started.
SEGMENT 2 SEGMENT 3 SEGMENT 4 SEGMENT 1
Memory Protected
ARM REC ARM REC ARM REC ARM REC
STOP VIEW STOP VIEW
event
trigger
automatic switching of the Camera mode and Segment
switching of the Camera mode with the JPAD3 operation
Figure 3-43 Event Recording (EVENT(A), Number of Segments: 4)
1) Verify that the MEMRECAM GX-3 is in the STOP mode.
2) While in the STOP mode, press VIEW/ARM
on the J-PAD3 to switch to the VIEW mode.
The memory segment number (SEG) superimposed on
the image shows "A". The AUTO mode settings are
displayed.
The frame counter (Frame) shows "E". The event
recording settings are displayed.
3) While in the VIEW mode, press VIEW/ARM
on the J-PAD3 to switch to the ARM mode.
While the images are overwritten to the appropriate memory segment (SEGMENT1), it awaits trigger
input.
4) While in the ARM mode, press TRIG on the J-PAD3 or use the external trigger for input to switch to
the REC mode. Continue to input event trigger signals from the TRIG1 connector on rear panel or the
J3 cable TRIG2 connector to save the event frames. Recording will end according to the set trigger
timing.
5) Once recording to the appropriate memory segment (SEGMENT1) has been completed, it switches to
the next memory segment (SEGMENT2) and automatically switches from the REC mode to the ARM
mode.
6) Repeat recording in 4)
～
5), and once recording to all of the memory segments has been completed, it
switches from the REC mode to the STOP mode. The memory segment does not automatically switch
after the final memory segment (SEGMENT4) recorded.
7) Memory protection applies to memory segments where the recording has been completed so it does
not switch to the ARM mode. If you want to record again, either change the settings to a recording
method other than the AUTO mode, or erase the memory segment.