NAC Image Technology MC-529, User Manual

Page: 150 / 180

(00235) 7-10
7.3 Video Converter
1) Output Signal NTSC / PAL method analog signal, 75 Ω , 1 V(p-p)
Image update rate 30 frame/sec (NTSC), 25frame/sec (PAL)
Display area 640x480(NTSC), 768x576(PAL)
2) Gradation Y, Cb, Cr each 8 bit (internal digital final stage)
3) Image Quality Settings
Gain LOW ､ NORMAL ､ HIGH
White balance AUTO
､
3100K
､
5000K
､
9000K
､
REG
Enhance OFF
､
LOW
､
NORMAL
､
HIGH
Gamma OFF ､ LOW ､ NORMAL
Chroma 0%
､
50%
､
100%
､
150%
､
200%
Knee OFF
､
ON
RGB matrix OFF ､ ON
LUMINANC NORMAL, LINEAR, CUSTOM (Only select)
4) Display
Zoom FIT1 (display the entire screen at 100%),
FIT2 (NTSC:display the entire screen reduced about 80%,
PAL:display the entire screen reduced about 83%),
1/2, 1x, 2x, 4x
Scroll The zoomed image is cut to the display area for display.
Coordinates are set using the center of the image as the origin,
and the display position can be moved.
5) Segment frame display Segment frame displayed in VIEW mode or LOW LIGHT mode.
Can be used in conjunction with zoom display.
6) Display mark at the center of the image
Cross can be displayed as the mark at the center of the image:
CAFM(Camera Alignment Fiducial Mark). Select either white or
black.
7) Playback display
Playback speed (NTSC) Forward, 1~1920 frames/sec, both forward and reverse
Playback speed (PAL) Forward, 1~2000 frames/sec, both forward and reverse
Frame jump Trigger frame, recording start frame, recording end frame
Playback mode Single playback (PLAY mode), loop playback (LOOP mode)
Playback range settings Playback start frame and playback end frame settings
Note) In the reproduction speed beyond 30 frame/sec, it skip and display an image (skipping an
intermediate frame). Therefore, if it plays at the rate of below 30 frame/sec recording on VTR etc.,
all the recorded images are recordable.( In PAL, the number of 30 is set to 25 here)
A frame number corresponds with an image.
A still picture image does not become like a double exposure.
8) Video output control Video output can be set to ON/OFF