NAC Image Technology MC-529, User Manual

Page: 124 / 180

(00233) 5-6
5.2 System Settings
Settings related to the system in Table 5-1, Table 5-2 and Table 5-3 are described below.
5.2.1 Allowed/Prohibited Settings for Operations on the Control PC (LOCK)
While the control PC is connected to the J3 cable ETHER connector, operations on the PC (camera
control using the control software GXLink) can be set as allowed/prohibited.
1) While in the STOP mode, press MENU to display the
TOP MENU.
2) Use the arrows to select "LOCK" from the TOP
MENU (Figure 5-4).
3) Use the arrows to select allow/prohibit operation of
the control PC.
OFF PC operation allowed
PC LOCK PC operation prohibited
5.2.2 ID Number Settings (ID)
The ID number can be set. ID numbers that can be set are from 0~127.
1) While in the STOP mode, press MENU to display the
TOP MENU.
2) Use the arrows to select "SYS MENU" from the TOP
MENU and press SET to display the SYS MENU.
3) Use the arrows to select "ID" from the SYS MENU
(Figure 5-5).
4) Use the arrows to move columns and use arrows
to change the numerical value.
(Range of settings: 0
～
127)
5) Press SET again to set the ID number.
Figure 5-4 LOCK
Figure 5-5 ID