NAC Image Technology MC-529, User Manual

Page: 83 / 180

(00235) 3-31
3.2.14.6.4 MULTIS(A)
Figure 3-40 shows how to switch modes with the J-PAD3 during MULTIS(A) recording (top of the figure)
and saving in the memory (bottom of the figure). MULTIS(A) is multi trigger recording in the AUTO mode.
The sequences for setting two memory segments and four blocks, and for MULTIS(A) recording to all of
the memory segments are shown below.
The memory should be empty before recording is started.
B1 B2
SEGMENT 1
STOP VIEW
ARM REC
B3 B4
ARM REC ARM REC ARM REC
B1 B2
SEGMENT 2
B3 B4
ARM REC ARM REC ARM REC ARM REC
Memory
Protected
STOP
VIEW
switching of the Camera mode with the JPAD3 operation
automatic switching of the Camera mode, Segment and Block
Figure3-40 Multi Trigger Recording (MULTIS(A), Number of Segments: 2, Number of Blocks: 4)
1) Verify that the MEMRECAM GX-3 is in the STOP mode.
2) While in the STOP mode, press VIEW/ARM
on the J-PAD3 to switch to the VIEW mode.
The memory segment number (SEG) superimposed on
the image shows "A". The AUTO mode settings are
displayed.
The frame counter (FRAME) superimposed on the image
shows "04 A". There are 4 blocks displaying the ALL
BLOCKS mode setting.
3) While in the VIEW mode, press VIEW/ARM on the J-PAD3 to switch to the ARM mode.
The frame counter (Frame) displays "01 A". While the
images are overwritten to block 1, it awaits trigger input.
4) While in the ARM mode, press TRIG on the J-PAD3 or use the external trigger for input to switch to
the REC mode. Recording will end according to the set trigger timing.
5) Once recording to the appropriate block (B1) has been completed, it switches to the next block (B2) and
automatically switches from the REC mode to the ARM mode.
6) Repeat recording in 4)
～
5), and once recording to all of the blocks in the appropriate memory segment
(SEGMENT1) has been completed, it switches to the next memory segment (SEGMENT2) and
automatically switches from the REC mode to the ARM mode.
7) If the recording operation from 6) is repeated and recording to all of the memory segments has been
completed, it switches from the REC mode to the STOP mode. The memory segment does not
automatically switch after the final memory segment (SEGMENT2) recorded.
Memory protection applies to memory segments where the recording has been completed so it does
not switch to the ARM mode. If you want to record again, either change the settings to a recording
method other than the AUTO mode, or erase the memory segment.