NAC Image Technology MC-529, User Manual

Page: 80 / 180

(00235) 3-28
5) Once recording to the appropriate memory segment (SEGMENT1) has been completed, it switches to
the next memory segment (SEGMENT2) and automatically switches from the REC mode to the ARM
mode.
6) Recording
in 4)
～
5) is repeated, and once recording to all of the memory segments has been completed,
it switches to the top memory segment (SEGMENT1) and automatically switches from the REC mode to
the ARM mode.
The recording operation in 6) can be repeated while subsequent images are overwritten. Press STOP
to stop recording.
* Press STOP to stop recording, even when recording to the appropriate memory segment has not
been completed. Depending on the camera mode when STOP is pressed, the number of frames
saved before recording is stopped will vary.
・
If STOP is pressed during the ARM mode
If the custom setting for the trigger timing is +100%, recording stops when the same number of
frames is saved.
・
If STOP is pressed during the REC mode
Recording stops after saving from the frame where recording was started to the frame at the instant
STOP
was pressed.
3.2.14.6 Multi Trigger Recording
With multi trigger recording, the appropriate memory segments can be segmented into a maximum of 16
uniform blocks. Triggers are input for each block and multiple images can be recorded separately.
Also, each time recording to blocks is completed, the blocks are switched and it automatically switches
from the REC mode to the ARM mode (ALL BLOCKS mode).
The four modes within multi trigger recording include MULTI(A), MULTI(C), MULTIS(A), and MULTIS(L).
Refer to
【
3.2.14.3 Setting Method
】
for the multi trigger recording settings and the settings for the number
of segmented blocks.
Next are the restrictions on multi trigger recording and the recording sequence for each mode.
3.2.14.6.1 Multi Trigger Recording Restrictions
The following restrictions apply to multi trigger recording.

Multi trigger recording cannot be combined with burst recording and event recording. Recording can
be combined with EST synchronized signal recording.

Automatic block switching takes about 2.5 seconds. Triggers input during this period may be
ignored so use trigger input after verifying that you are in the ARM mode.