NAC Image Technology MC-529, User Manual

Page: 36 / 180

(00235) 2-8
2.5 Live Image Display (VIEW Mode)
■
Switching to VIEW mode
Press VIEW/ARM .
In the STOP mode, access the VIEW mode each time J-PAD3 VIEW/ARM
is pressed.
Set the recording conditions in the VIEW mode. Refer to
【
3 Recording and Playback Settings
】
for the
settings for recording conditions.
■
Image Display
In the VIEW mode, the image photographed is
displayed live. The superimposed information is
displayed at the top and bottom of the screen, and
the camera mode (STATUS) is shown as "VIEW"
(Figure 2-11).
The superimposed information shown in red is the
current recording conditions. If the recording
conditions are changed, the live image and the
superimposed information are also changed.
Trigger time or the present time recorded on the
image to record is displayed on a trigger (Trigger).
Refer to
【
5.2.6 OSD TIME
】
for setting for OSD
conditions.
The time of image trigger selection, it is displayed on
trigger (Trigger) as Image Trigger, and the background
of an information display of OSD becomes blue
(Figure 2-12).
■
J-PAD3 Display
The status screen is shown in Figure 2-13, and
the camera mode "VIEW" is displayed. The current
recording conditions are shown on the status screen
during VIEW. If the recording conditions are
changed, status screen is also changed.
The status screen information for the frame
counter (Frame) and the frame time (Time) remain
unchanged from that of the STOP mode.
■
Rear Panel LED Display
During the STOP mode,the CM LED is lit up in white.
Figure 2-11 Image Display (VIEW Mode)
Figure 2-13 J-PAD3 Display (VIEW Mode)
Figure 2-12 Image Display (VIEW Mode)
Image trigger selection