NAC Image Technology MC-529, User Manual

Page: 37 / 180

(00235) 2-9
2.6 Recording
The MEMRECAM GX-3 memory is comprised of a ring buffer (a circular memory) where the first recorded
image and the last recorded image are connected for saving. Recording starts with a photographed image
which is sequentially saved in the ring buffer (memory). After the ring buffer completes one cycle, the
subsequent new image is written over. This state continues until recording trigger signals are input.
If recording triggers include the following three kinds of triggers and one of recording triggers is detected, I
will record the number of recording flames set up by
【
3.2.1 Selection of recording timing
】
, and will end
recording.
・
J-PAD3 and the trigger command from reactor-control software
・
Input thje external trigger signal (TRIG 1 line connector of a rear panel, TRIG 2 line connector of J3
cable)
・
Image trigger (Refer to
【
3.2.7 image trigger function
】
)
Switch to the camera mode for recording. Use the remote control J-PAD3 to switch to the camera mode
(Figure 2-14).
Figure 2-13 Summary of Operations with the J-PAD3