NAC Image Technology MC-529, User Manual

Page: 79 / 180

(00235) 3-27
* Press STOP even when recording to the appropriate memory segment has not been completed to
stop recording. Depending on the camera mode when STOP is pressed, the number of frames
saved before recording is stopped will vary.
・
If STOP is pressed during the ARM mode
If the custom setting for the trigger timing is +100%, recording stops when the same number of
frames is saved.
・
If STOP is pressed during the REC mode
Recording stops after saving from the frame where recording was started to the frame at the instant
STOP
was pressed.
3.2.14.5.4 BURST(L)
Figure 3-37 shows how to switch modes with the J-PAD3 during BURST(L) recording (top of the figure)
and saving in the memory (bottom of the figure). BURST(L) refers to burst recording in LOOP mode. B1, B2,
B3 and B4 refer to memory segmented blocks that correspond to the burst trigger signals.
The sequence for segmenting the memory into four memory segments and performing BURST(L)
recording for all of the memory segments is shown below.
B1 B2 B1 B2 B3 B1 B2 B1 B2 B3 B4
SEGMENT 1 SEGMENT 2 SEGMENT 3 SEGMENT 4
STOP VIEW
REC REC
ARM ARM
REC REC
ARM ARM
burst trigger
on
switching of the Camera mode with the JPAD3 operation
automatic switching of the Camera mode and Segment
Figure3-37 Burst Recording (BURST(L), Number of Segments
：
4)
1) Verify that the MEMRECAM GX-3 is in the STOP mode.
2) While in the STOP mode, press VIEW/ARM
on the J-PAD3 to switch to the VIEW mode.
The memory segment number (SEG) superimposed on
the image is displayed as "L". Settings in LOOP mode are
displayed.
"B" is shown in the frame counter (Frame). Burst recording
settings are displayed.
"BURST" is displayed for trigger timing (Trigger).
3) While in the VIEW mode, press VIEW/ARM
on the J-PAD3 to switch to the ARM mode.
During burst recording, images cannot be overwritten, even in ARM mode. Also, live images cannot be
updated.
4) While in the ARM mode, input the burst trigger signals from the J1 cable TRIG1 connector or the J3
cable TRIG2 connector to switch to the REC mode.
Images are saved only when the burst trigger signal is ON, and when live images are updated.
Recording ends after the number of frames for the appropriate memory segment (SEGMENT1) are
saved.