NAC Image Technology MC-529, User Manual

Page: 39 / 180

(00235) 2-11
2.6.2 REC Mode
■
Switching to REC Mode
Press TRIG . Or, input the external trigger signal.
In the ARM mode, access the REC mode each time J-PAD3 TRIG is pressed or when an external
trigger signal is input from TRIG 1 line connector of a rear panel. Refer to
【
3.2.12 External Trigger Signal
Selection
】
for external trigger input.
Once into the REC mode, recording ends according to the set trigger timing. Refer to
【
3.2.1 Trigger
Timing Selection
】
for trigger timing.
Once recording stops, it switches to the STOP mode.
。
■
Image Display
In the REC mode, the image photographed is
displayed live. The superimposed information is
displayed at the top and bottom of the screen, and
the camera mode (STATUS) is shown as "REC"
(Figure 2-17).
After trigger input, the value for the frame counter
(Frame) is lowered for each recorded frame saved.
With Trigger, "*" is displayed until recording has
ended.
■
J-PAD-3 Display
The status screen is shown in Figure 2-17, and
the camera mode "REC" is displayed. The
established recording conditions are shown in the
REC mode status screen.
The frame "TIME" cannot be determined until
recording has ended, so "
＊
" is shown.
"0" is shown in the frame counter (FRAME) until
recording has ended.
■
Rear Panel LED Display
During the STOP mode,the CM LED is lit up in orange.
。
Figure 2-17 Image Display (REC Mode)
Figure 2-18 J-PAD3 Display (REC Mode)