REAR AXLE
Differential Carrier
(6) Install the drive pinion assembly and companion flange
with mating marks properly aligned, and tighten the
companion flange self-locking nut to the specified
torque by using the special tools.
Measure the drive pinion turning torque (with oil seal) to
verify that the drive pinion turning torque complies with
the standard value.
Standard value:
Bearing
Bearing
classification lubrication
Rotation torque
(starting friction torque)
If there is a deviation from the standard value, check
whether or not there is incorrect tightening torque of
the companion flange tightening self-locking nut, or
incorrect fitting of the oil seal.
. ADJUSTMENT OF DIFFERENTIAL GEAR BACKLASH
Adjust the differential gear backlash by the following
procedures:
(1) Assemble the side gears, side gear spacers, pinion
gears, and pinion washers into the differential case.
(2) Temporarily install the pinion shaft.
NOTE
Do not drive in the lock pin yet.
(3) Adjust the differential gear backlash by the following
procedures:
While locking the side gear with the wedge,
measure the differential gear backlash with a dial
indicator on the pinion gear.
NOTE
The measurement should be made for both pinion
gears individually.
Standard value:
mm
in.)
Limit:
0.2 mm
Summary of Contents for 1989 Galant
