Mitsubishi 1989 Galant, Service Manual

Page: 540 / 1273

13-398
AUTO-CRUISE CONTROL SYSTEM
Adjustment
1
AUTO-CRUISE CONTROL CANCELLATION CHECK
(1) Set the auto-cruise control.
(2) Check to be sure that there is
a return to ordinary driving,
and that the illumination of the auto-cruise indicator stops,
when either of the operations below is performed.
The brake pedal is depressed.
The clutch pedal is depressed.
lever is moved to the “N” or “P” range.
The auto-cruise control main switch is switched OFF.
The ignition switch is turned to OFF.
C H E C K O F R E T U R N T O T H E S E T S P E E D B E F O R E
CANCELLATION
(1) Set the auto-cruise control.
(2) Check to be sure that the auto-cruise control is
when either of the operations below is performed.
The brake pedal is depressed.
The clutch pedal is depressed.
The shift lever is moved to the “N” range.
(3) Turn the control switch to RESUME position and release
(RESUME switch ON
while driving at a vehicle
speed of approximately 40 km/h (25 mph) or higher.
(4) After switching RESUME switch to OFF, check to be sure
that there is a return to the auto-cruise control speed before
it will be and the vehicle will travel at the constant
speed.
A C C E L E R A T O R C A B L E S
ADJUSTMENT
<Electrical type: Up to 1990 models>
(
I
)
Turn air conditioning and lights OFF.
Inspect and adjust at no load.
(2) Warm engine until stabilized at idle.
(3) Confirm idle speed is at prescribed rpm.
(4) Stop engine (ignition switch OFF).
(5) Confirm there are no sharp bends in accelerator cables.
(6) Check inner cables for correct slack.
(7) If there is too much slack or no slack, adjust play by the
following procedures.
Remove the actuator’s protector.
On models with an SOHC engine, turn the ignition
switch to the ON position (without starting the engine)
and leave in that condition for approximately 15
seconds.
TSB Revision