SERVICE BRAKES
Rear Drum Brake/Rear Brake Wheel Cylinder
11
(5) Then once again tighten the wheel bearing nut to
Nm (7
(6) Install the lock
cap
and split pin.
(7) If the position of the cotter pin is not matched with the
holes of the lock cap, reposition the lock cap so that the
holes align. If this can not be accomplished, back off the
nut by not more than 15”.
Caution
Check to be sure that the lock nut cannot
b e
loosened manually.
(8) After setting the split pin in place, seat the bearing in
the same manner as in step (2).
REAR BRAKE WHEEL CYLINDER
REMOVAL AND INSTALLATION
8 - 1 2
6 - 9
/ -
Removal steps
Adjusting of wheel bearing end play
(Refer to GROUP
Procedures.)
1. Hub cap
2. Cotter pin
3.
Lock cap
4. Wheel bearing nut
5. Tongued washer
6. Outer wheel bearing inner race
7. Brake drum
8. Shoe-to-lever spring
9. Shoe-to-shoe spring
Bleeder screw
11. Brake tube
cylinder assembly
Pre-removal Operation
l
Draininq of Brake Fluid
l
Bleeding (Refer to
TSB
Revision
Summary of Contents for 1989 Galant
