Mitsubishi 1989 Galant, Service Manual

Page: 43 / 1273

GENERAL Maintenance Service
6. DRIVE BELT (For Water Pump and
Generator) (Inspect for tension)
Place straight edge as shown in the illustration.
(2) Measure the deflection with a force of (22
applied to belt mid-point between water pump pulley
and generator pulley. If the standard value is not ob-
tained, make adjustment.
value: 1.5 mm in.)
(3) Use a tension gauge to check the belt tension. If the
standard value is not obtained, make adjustment.
When tension gauge is used, the tension may be
measured between any two pulleys.
Standard value:
7. ENGINE OIL (Change)
Always use lubricants which conform to the requirements
of the API classification “For Service SG” or “For Service
when available, and have the proper SAE grade
number for the expected temperature range.
Never
nondetergent or straight mineral oil.
(1) After warming up the engine, remove the oil filler cap.
(2) Remove the drain plug to drain the engine oil.
(3) Replace the drain plug gasket with a new one and
tighten the drain plug.
(4) Supply new engine oil through the oil filler.
Engiine oil capacity:
Items
Engine oil capacity
Oil pan
Models built up to SOHC
3.5 (3.7 qts.)
April 1992
DOHC 4.0 (4.2 qts.)
Models built from May 1992
4.0 (4.2 qts.)
Oil filter
0.3 qt.)
Oil cooler models with turbo)
0.3 qt.)
(5) Start and run the engine a few minutes.
(6) Stop the engine and check the engine oil level.
8. ENGINE OIL FILTER (Change)
The quality of replacement filters varies considerably. Only
high filters should be used to assure most efficient
service.
Genuine oil filters require that the filter is capable of
a pressure of 256 psi are high quality filters
and are recommended as follows:
Oil Filter Part No.
Mitsubishi Genuine Parts:
TSB Revision