Mitsubishi MOTORS Outlander Sport 2019, Owner'S Manual

Page: 289 / 361

How to change a tire
8-8 For emergencies
8
3. Rotate the jack by hand until the flange
portion (B) fits in the groove (C) at the top
of the jack.
4. Make sure that the flange portion at the
jacking point fits in the groove at the top
of the jack. Insert the bar (D) into the
wheel nut wrench (E). Then put the end of
the bar into the shaft’s jack end, as shown
in the illustration.
Slowly rotate the wheel nut wrench until
the tire is raised slightly off the ground
surface.
WARNING
 Set the jack only at the positions shown
here. If the jack is set at a wrong position,
it could dent your vehicle or the jack
might fall over and cause personal injury.
 Do not use the jack on a tilted or soft sur-
face.
Otherwise, the jack might slip and cause
personal injury. Always use the jack on a
flat, hard surface. Before setting the jack,
make sure there are no sand or pebbles
under the jack base.
NOTE
 Put the spare wheel under the vehicle body
near the jack. This makes it safer if the jack
slips out of position.
WARNING
 Stop jacking up the vehicle as soon as the
tire is raised off the ground. It is danger-
ous to raise the vehicle any higher.
 Do not get under your vehicle while using
the jack.
 Do not bump the raised vehicle or leave it
sitting on the jack for a long time. Both
are very dangerous.
 Do not use a jack except the one that came
with your vehicle.
 The jack should not be used for any pur-
pose other than to change a tire.
 No one should be in your vehicle when
using the jack.
 Do not start or run the engine while your
vehicle is on the jack.
BK0265500US.book 8 ページ ２０１８年５月８日 火曜日 午後８時７分