Mitsubishi MOTORS Outlander Sport 2019, Owner'S Manual

Page: 41 / 361

Child restraint systems
4-18 Seat and restraint systems
4
The airbag control unit monitors the readiness
of the electronic parts of the system whenever
the ignition switch or the operation mode is
under the following conditions. These include
all of the items listed above and all related
wiring.
[Except for vehicles equipped with the
F.A.S.T.-key]
The ignition switch is in the “ON” or
“START” position.
[Vehicles equipped with the F.A.S.T.-key]
The operation mode is in ON.
The seat belt pre-tensioners will operate
under the same conditions as the airbag con-
trol unit.
When the seat belt pre-tensioners activate,
some smoke is released and a loud noise will
be heard. The smoke is not harmful, but care
should be taken not to intentionally inhale it,
as it may cause some temporary irritation to
people with respiratory problems.
Even in the event of a severe impact, the pre-
tensioners will not operate if the seat belts are
not fastened. The seat belt pre-tensioners may
not activate in certain collisions, even though
the vehicle may appear to be severely dam-
aged. Such non-activation does not mean that
something is wrong with the seat belt pre-ten-
sioner system, but rather that the collision
forces were not severe enough to activate the
system.
N00408700081
This warning light tells you if there is a prob-
lem involving the SRS airbags and the seat
belt pre-tensioner system. Refer to “SRS
warning light/display” on page 4-32.
N00408901149
In the event of an accident, the seat belt force
limiter system will help reduce the force
applied to the driver and front seat passenger.
N00407101854
When transporting infants or small children
in your vehicle, an appropriate child restraint
system must always be used. This is required
by law in the U.S. and Canada.
Child restraint systems specifically designed
for infants and small children are offered by
several manufacturers. Choose only a child
restraint system with a label certifying that it
complies with Federal Motor Vehicle Safety
Standard 213 (FMVSS 213) or Motor Vehicle
Restraint Systems and Booster Seats Safety
Regulations (RSSR). Look for the manufac-
turer’s statement of compliance on the box
and child restraint system itself.
1- SRS warning light
2- Front impact sensors
3- Seat belt pre-tensioner
4- Airbag control unit
5- Side impact sensors
6- Seat belt buckle switches
WARNING
 The seat belt pre-tensioner system is
designed to work only once. After the seat
belt pre-tensioners have been activated,
they will not work again. They must
promptly be replaced and the entire seat
belt pre-tensioner system inspected by an
authorized Mitsubishi Motors dealer.
SRS warning
Force limiter system
Child restraint systems
BK0265500US.book 18 ページ ２０１８年５月８日 火曜日 午後８時７分